How I Made the Belt on Sara's House

This is the last post I'll make about the belt at the top of Sara's dollhouse. I promise! I just had to tell a little more about how I made it. Please do click on the photo to see it close up. The circles were wooden toy wheels that I bought at a Michaels store.

The wheels were approximately 1/8" thick and had a hole in the center that was just the right size for a 1/8" piece of doweling to fit snugly into. I drilled a 1/8" hole into a piece of 1 x 2 board and then set my table saw so that the fence was about 3/4" depth from the blade. The width of the blade is about 1/16", and so running the 1 x 2 past the blade, the saw would slice off the back half of a wheel (as long as the wheel was pushed flat against the 1 x 2).

I allowed a length of the dowel to protrude through the front of the wheel, because I held onto that piece of doweling to control the cut wheel. If I had not done this, my saw would have flung the wheels at me and all around my workshop! In fact, a couple of times, the doweling broke, in the cutting process, and that's EXACTLY what happened. (Flying saucers anyone?)

Painting Was a Challenge!
Painting these circles was a challenge. I had to do that free-hand. I used the 1/8" dowel once again to hold them while I painted, which made the task a little easier. The golden center of each circle is a brass tack that has a rounded head. I cut the nails down to a short length and glued one into the hole of each circle.

I cut the green pieces out of basswood, cutting out first the outline, then drilled a hole and carefully cut out the centers. Then I went through a dozen emery boards, which I wore out sanding the top edges of these pieces until they were rounded.

I've already told you about the brackets. I ended up making several more than the 24 that I put on the house. Sometimes they'd break on me when I tried to peel them apart from the double-stick tape. Other times, I just didn't do a good job of cutting out the fancy insides and had to start over again. People always say, "You must be a really patient guy." The truth of the matter is that I'm more of a perfectionist than I am patient, which means I often end up having to redo things because I got in too much of a hurry!