Sunday, April 18, 2010

Easy to Build Furniture

It's been too long since I posted anything on my blog. I've been up to my eyeballs with work, and haven't had any time to write! So sorry. I'm still crazed with work, but I just HAD to put something out on my blog. I value your readership - all 150 of you!

I got to thinking that some of you might appreciate some ideas for some simple furniture pieces that shouldn't be too hard to produce. At the left is just such a project. 

I encourage you to click on the image and take a screen print of the drawing. Paste it into a Word document and then print it out. You may have to adjust the size of the picture. I marked the width of the back of the chair; so you should have an idea of how much to blow up or reduce the chair on your own computer. I made this storage chair for our Christmas gift exchange in our miniature club many years ago. It has no fancy joinery, and the only tricky thing is to make sure you drill so that you can insert pins into the chair seat.

Here are the instructions:
1. Cut out all of the parts from 3/32/" thick cherry or bass wood. Sand the pieces smooth.
2. Trial fit the parts to make sure they fit properly.
3. Glue the back to the base piece.
4. Glue the sides onto the base and back. (If you intend to stain the piece, be careful to wipe away any excess glue right away with a damp cloth.)
5. Glue the spacers onto INSIDE of the sides. Make sure there's at least a quarter inch of clearance between the back of the spacers and the back of the chair.
6. Trial fit the front onto the chair. Sand any excess wood at the base or sides that protrude from the bottom or from the sides. Then glue it into place.
7. Use some sandpaper or emery board to round the front and back top edge of the seat.
8. Set the seat into place. Put a business card between the chair seat and the chair back so that there's a small gap. Now drill a pin-sized hole on each side of the chair where it's marked with an X in the diagram. (If you don't trust the diagram, you can set the seat in, then take a try square and line it up with the protruding seat to have a sense of where to place the pin. 
9. Once you have drilled your hole into the chair sides and the seat, snip about 1/4" of the sharp end of a straight pin and gently push it into the hold you have drilled. If the pin is too long, you can pull it out slightly, snip a little off and push it in again. You want the pin to be flush with the surface of the chair sides.
10. Stain and varnish the chair or you may have fun tole painting it!

Hope this works well for you. If not, you know where to reach me! Enjoy!

7 comments:

dalesdreams said...

This is great! Is this your own pattern?

George the Miniguy said...

Yes, it is.
;o)

Geo.

The Dangerous Mezzo said...

George, thank you so much -- I'm going to enjoy building this chair. It will go perfectly in just about all the houses I'm building :)

Michelle said...

Oh this is great! Just what I need for Hogwarts (Common Room). Will give it a go!

Michelle :o)

Chris said...

Thanks for this description, George!

Nina, the Wonder-Wench said...

As a new follower I find your site most amazingly helpful! :) Than you so much! Soon my witch will have her wingback chair, I think... ;)
Kind regards from Finland!

meggiecat said...

Lovely chair. Thank you.

Related Posts with Thumbnails